2012, 04-27 Permit App: BLD-2012-0504 Finish BasementSpokane
Valley
Community Development Department
Permit Center
11703 East Sprague Avenue, Suite B-3
Spokane Valley, WA 99206
Tel: (509) 688-0036
Fax: (509) 688-0037
Permitcenter@sooka nevallev.orq
(Staff Use Only)
PERMIT NUMBER:
PERMIT FEE:
-D-2oc2-
RESIDENTIAL CONSTRUCTION PERMIT APPLICATION
0 NEW CONSTRUCTION i`1 ADDITION/REMODEL
0 DECK 0 OTHER
SITE ADDRESS: /00 10 Ec`5 i- gj 00/U L
0 ACCESSORY BUILDING
ASSESSORS PARCEL NO.: LEGAL DESCRIPTION:
BUILDING OWNER NAME:
NAME:
////; L c4f/50i✓ KoyGt&,k
ADDRESS: /00/ U ( c, 5 T BOte)Jv
CITY•
PHONE: S7 — % t7— :o `f v
CONTACT NAME:
/7) //�
STATE:
Le
ZIP:
FAX: CELL:
PHONE: S - 5,q SJYCJ
FAX: CELL:
CONTRACTOR NAME: nrytef, c 4 s C0A-f /4 c,C,,
0 I GL i i J i✓ .rsi1 C
MAILING ADDRESS: 2/ 7
7z --
CITY: CITY: �/Of
• C 91/ -�/0
PHONE:
STATE:
t / I
ZIP: c;.2 5
CONTRACTOR LIC
FAX: CELL: SCS 5' ll //- 5-26 2
EXPIRES: CITY BUSINESS LICENSE NO.: (00,2 -5 -6s -
DESCRIBE THE SCOPE OF WORK IN DETAIL AND INDICAT USE & PROPOSED USE:
h� g k I0 77S 0Q,t-- �'%/1 j13�s� p —(<n
7 /AckdC (%N g \�Dv/i'- Bc/h!o - L4r1nmC.2 !`dc) ✓✓`
111)" tie) 12°C)f ****YOU MUST COMPLETE THE FOLLOWING****
MARK N/A IF NOT APPLICABLE
Height to Peak:/--.
Dimensions/ , i
X�2-
No. of Stories:
/
Total Habitable
Space:
Main Floor SQ FI;,,,.,._Upper
j 7� ,
Floor SQ FT:
Unfinished Basement SQ
FT: 775—'9
Finished Basement SQ
FT:
Garage SQ FT:
Deck/Covered Patio SQ
FT:
Impervious Surface
Area:
30% Slopes on
Property:
No. of Bedrooms:
Construction Type:
Heat Source: (0,,3 Fi <e-
Sewer or Septic: SP,. -'e /
TOTAL COST OF PROJECT: $ 0oO c" --)c)
DISCLAIMER
The permitted verifies, acknowledges and agrees by their signature that: 1) if this permit is for construction or on a dwelling, the dwelling is/will
be served by potable water. 2) Ownership of this City of Spokane Valley permit inure to the property owner. 3) The signatory is the property
owner or has permission to represent the property owner in this transaction. 4) All construction is to be done in full compliance with the City of
Spokane Valley Development code. Referenced codes are available for review at the City of Spokane Valley Permit Center. 5) The City of
Spokane Valley permit is ngt rmit or approval for any violation of federal, state or local laws, codes or ordinances. 6) Plans or additional
information may be�red to s}abm ar i subsuently approved before this application can be processed.
Signatue
Date: /7---(2 7- w�
Upda6 1-11-11 Page 1 of 1
http://www.spokanevalley.org/filestorage/124/938/210/948/1496/Building_Permit= _Residential_11-11-11.doc
RESIDENTIAL CHECK LIST DIRECTIONS:
Place a check mark in box next to each document required for comptete submittal.
• SITE PLAN
o Property lines and dimensions
o Direction arrow pointing North and orientation to streets
o Proposed/existing buildings (footprint and dimensions)
O Utilities, septic tank/drain field locations and distances
o Setbackto property lines
o Distance between buildings
o Right of way/easement Iocation & sizes
o Driveway approach size and Iocation
BUILDING PLANS (3 SETS) (minimum 1/8 inch scale or completely dimensioned)
O Elevations (Front/Rear/Sides) with roof peak and wall height including basement:
O Foundation PIan (crawlspace, basement or slab on grade):
o Footing sizes and locations
o Perimeter concrete foundation waH sizes
o Craw|opoceventilation
o Supporting wood cripple walis or beams
o Thickened concrete pads supporting
beams or girder trusses
O Floor PIan of each level or unfinished) with dimensions:
O Floor Joist direction, size and spacing 0 Window and door !ocation and sizes
o Window well Iocations if applicable
o Room usage labels
oSmoke detector locations
o Attic and crawspace access Iocations
o Fire Wall construction
o Header, beam or concrete Iintelsizes
o Brace wall panel Iocations
o Water heater and furnace Iocations
O Exhaust fan locations
o Deck or concrete patio sizes and Iocations
O Roof Plan:
o Engineered truss direction and spacing
o Rafter and over frame direction, size and spacing
O Wadl Section Detail inctuding:
Roof
o Slope/ roofing material/ underlayment/ ice dam protection
o Sheathing size and type
Ceiling
o Joist size and spacing
Wall
o Height/ top plate/ stud size and spacing/ sole plate
o Exterior sheathing size and type
Floor
o Joist size and spacing
Foundation Wall
o Concrete or Masonry unit width
o Earth to wood separation distance
Footing
o Size
Radon
o Passive system with 6m11 vapor barrier
Miscellaneous Construction DetaHs
O Deck:
o Floor plan/ side view/ dimensions
o Foor Joist/ decking direction, size and spacing
O Stairway tread rise & run and nosing
o Ridgeeave and valley lines
o Beam and girder size and location
o Truss or rafter size, spacing & connection
o Attic insulation/ air space baffle/ ventitation
o Size of ceiling gypsum waboard
o Sidingexterior house wrap/ anchor bolts
o Insulation, vapor barrier, gypsum wall board
o Sheathing or concrete floor size/ insulation
O Footing bottom to finished ground level depth
o Horizontal & vertical reinforcement if any
o Reinforcement if any
o Active system with 6 mil vapor barrier
o Footings/ post/ and beam size and locations
O Handrail / Guard height & spacing
tp, 4•1,, e
VCYYirAo-
•
N.)
SFS care
d
I f►', ,`r)Ee DamOINMGPLIANCE
vsiz-
•EJ WEIS
N
RECEIVED
CS V PERMIT CENTER
Pfoject �',y�
Name o d ., '- 5 :>
Submittal ,e�
CITY COPY
3i-EDO € hit/WA-
/sit
Per40CI:62,tit-crams rave - 'S
eArst7-77'i of
ade't"
I �ttdtil 303
6'01-4 Plrlot'S`
/.h4O ti5E, ,,t,
T2-- `t
eg
SECTION 303
EQUIPMENT AND APPLIANCE LOCATION
303.1 General. Equipment and appliances shall be located as
required by this section, specific requirements elsewhere in this
code and the conditions of the equipment and appliance listing.
303.2 Hazardous locations. Appliances shall not be located in
a hazardous location unless listed and approved for the specific
installation.
303.3 Prohibited locations. Fuel -fired appliances shall not be
located in, or obtain combustion air from, any of the following
rooms or spaces:
1. Sleeping rooms.
2. Bathrooms.
3. Toilet rooms.
4. Storage closets.
5. Surgical rooms.
Exception: This section shall not apply to the following
appliances:
1. Direct -vent appliances that obtain all combustion air
directly from the outdoors.
2. Solid fuel -fired appliances, provided that the room is
not a confined space and the building is not of unusu-
ally tight construction.
3. Appliances installed in a dedicated enclosure in
which all combustion air is taken directly from the
outdoors, in accordance with Chapter 7. Access to
such enclosure shall be through a solid door,
weather-stripped in accordance with the exterior door
air leakage requirements of the International Energy
Conservation Code and equipped with an approved
self-closing device.
303.4 Protection from damage. Appliances shall not be
installed in a location where subject to mechanical damage
unless protected by approved barriers.
303.5 Indoor locations. Fuel -fired furnaces, water heaters and
boilers installed in closets and alcoves shall be listed for such
installation. For purposes of this section, a closet or alcove shall
be defined as a room or space having a volume less than 12
times the total volume of fuel -fired appliances other than boil-
ers and less than 16 times the total volume of boilers. Room
volume shall be computed using the gross floor area and the
actual ceiling height up to a maximum computation height of 8
feet (2438 mrn).
303.6 Outdoor locations. Appliances installed in other than
indoor locations shall be listed and labeled for outdoor installa-
tion.
303.7 Pit locations. Appliances installed in pits or excavations
shall not come in direct contact with the surrounding soil. The
sides of the pit or excavation shall be held back a minimum of
12 inches (305 mm) from the appliance. Where the depth
exceeds 12 inches (305 mm) below adjoining grade, the walls
of the pit or excavation shall be lined with concrete or masonry.
Such concrete or masonry shall extend a minimum of 4 inches
(102 mm) above adjoining grade and shall have sufficient lat-
GENERAL REGULATIONS
eral load-bearing capacity to resist collapse. The appliance
shall be protected from flooding in an approved manner.
[B] 303.8 Elevator shafts. Mechanical systems shall not be
located in an elevator shaft.
SECTION 304
INSTALLATION
304.1 General. Equipment and appliances shall be installed as
required by the terms of their approval, in accordance with the
conditions of the listing, the manufacturer's installation
instructions and this code. Manufacturer's installation instruc-
tions shall be available on the job site at the time of inspection.
304.2 Conflicts. Where conflicts between this code and the
conditions of listing or the manufacturer's installation instruc-
tions occur, the provisions of this code shall apply.
Exception: Where a code provision is less restrictive than
the conditions of the listing of the equipment or appliance or
the manufacturer's installation instructions, the conditions
of the listing and the manufacturer's installation instructions
shall apply.
304.3 Elevation of ignition source. Equipment and appliances
having an ignition source and located in hazardous locations
and public garages, private garages, repair garages, automotive
motor fuel -dispensing facilities and parking garages shall be
elevated such that the source of ignition is not less than 18
inches (457 mm) above the floor surface on which the equip-
ment or appliance rests. For the purpose of this section, rooms
or spaces that are not part of the living space of a dwelling unit
and that communicate directly with a private garage through
openings shall be considered to be part of the private garage.
304.3.1 Parking garages. Connection of a parking garage
with any room in which there is a fuel -fired appliance shall
be by means of a vestibule providing a two -doorway separa-
tion, except that a single door is permitted where the sources
of ignition in the appliance are elevated in accordance with
Section 304.3.
Exception: This section shall not apply to appliance
installations complying with Section 304.6.
304.4 Prohibited equipment and appliance location. Equip-
ment and appliances having an ignition source shall not be
installed in Group H occupancies or control areas where open
use, handling or dispensing of combustible, flammable or
explosive materials occurs.
[FG] 304.5 Hydrogen -generating and refueling operations.
Ventilation shall be required in accordance with Section
304.5.1, 304.5.2 or 304.5.3 in public garages, private garages,
repair garages, automotive service stations and parking
garages that contain hydrogen -generating appliances or refuel-
ing systems. For the purpose of this section, rooms or spaces
that are not part of the living space of a dwelling unit and that
communicate directly with a private garage through openings
shall be considered to be part of the private garage.
[FG] 304.5.1 Natural ventilation. Indoor locations intended
for hydrogen -generating or refueling operations shall be lim-
ited to a maximum floor area of 850 square feet (79 m2) and
2009 INTERNATIONAL MECHANICAL CODE® 21
1