2012, 10-16 Permit App: BLD-2012-2244 Carport�valleyx
immunity Development Department
Permit Center ,
11703 East Sprague Avenue, Suite B-3
Spokane Valley, WA 99206
Tel: (509) 688-0036
Fax: (509) 688-0037
permitcenter@sookaneval lev.orq
(Staff Use Only)
PERMIT NUMBER:
PERMIT FEE:
RESIDENTIAL CONSTRUCTION PERMIT APPLICATION
D NEW CONSTRUCTION 0 ADDITION/REMODEL ACCESSORY BUILDING
❑ DECK 0 OTHER !!!
SITE ADDRESS:
I7Loq coach
ASSESSORS PARCEL NO.: LEG L DESCRIPTION:
BUILDING OWNER NAME: L9/ ,het- W,? . is:0A
NAME: 6i`l Jet / 1Ah41 t64
ADDRESS: (.7'keiti ( a -/1
CITY: Sp 0 a" Vit1 STATE:
PHONE: 9-2.267 (239 FAX:
CONTACT NAME: b i ,i/( c(t
PHONE: q'7/ qc), j
CONTRACTOR NAME: wtter
wA
CELL:
FAX: CELL:
c3
MAILING ADDRESS:
CITY:
STATE:
Zi':
U)
PHONE:
FAX: CELL:
CONTRACTOR LICENSE No.:
EXPIRES: CITY BUSINESS LICENSE NO.:
DESC IBE T OPE F WORK IN DETAIL AND INDICATE USE & PROPOSED USE:
Ze
****YOU MUST COMPLETE THE FOLLOWING****
MARK N/A IF NOT APPLICABLE
Height to Pr:
g
Dimensi s: No. of Storigs:
vt e2c' r
Total Habitable
Space:
Main FloorFT:L
UpperMr SQ FT: Unfinished cement SQ
FT:
Finished a e ent SQ
FT:
{'V �/J
Garage SQ FT:
Deck Covere Patio SQ Impervious Surface
FT: 1 t Area: NA -
30% Slopes on
Property: NA '
No. of Bedrooms: AM-
Construction Type: idect4 Heat Source: NA..
Sewer r Septic.
TOTAL COST OF PROJECT: $
$, c t CSC)
DISCLAIMER
The permitted verifies, acknowledges and agrees by their signature that: 1) if this permit is for construction or on a dwelling, the dwelling is/will
be served by potable water. 2) Ownership of this City of Spokane Valley permit inure to the property owner. 3) The signatory is the property
owner or has permission to represent the property owner in this transaction. 4) All construction is to be done in full compliance with the City of
Spokane Valley Development code. Referenced codes are available for review at the City of Spokane Valley Permit Center. 5) The City of
Spokane Valley permit is not a permit or approval for any violation of federal, state or local laws, codes or ordinances. 6) Plans or additional
information may be required to be submitted and subsequently approved before this application can be processed.
Signature //J��
Date: /04 -1Z
Updated 1-11-11 Page 1 of 1
http://www.spokanevalley.org/filestorage/124/938/210/948/1496/Building_Permit_=Residential_11-11-11.doc
»+-
RESIDENTIAL CI-reCK LIST DIRECTIONS:
Place a check mark in box next to each document required kir complete submittal.
o SITE PLAN
o Property Iines and dimensions
o Direction arrow pointing North and orientation to streets
o Proposed/existing buildings (footprint and dimensions)
o Utilities, septic tank/drain field locations and distances
o Setbacks to property lines
o Distance between buildings
o Right of way/easement Iocation & sizes
o Driveway approach size and Iocation
BUILDING PLANS (3 SETS) (minimum 1/8 inch scale or comp!etely dimensioned)
O Elevations (Front/Rear/Sides) with roof peak and wall height including basement:
O Foundation Plan basement or s!ab on grade):
o Footing sizes and Iocations
o Perimeter concrete foundation wafl sizes
OCnsvv/speceventilation
•
o Supporting woocrippte walls or beams
o Thickened concrete pads supporting
beams or girder trusses
O Floor Pan ofeach level(finished or unfinished) with dimensions:
o FloorJoitdirection, size and spacing
o Header, beam cvconcrete lintel sizes
o Brace wa|l:pona|locations
o Water heater and furnace Iocations
o Exhaust fan locations
o Deck or.concrete patio sizes and Iocations
B Roof Plan:
o Engineered truss direction and spacing
o Rafter and over frame direction, size and spacing
O Wall Section Detail including:
Roof
o Slope/ roofing material/ undedaynnenUice dam protection
o Sheathing size and type
Ceiling
o Joist size and spacing
Wall
o Height/ top platel stud size and sole plate
o Exterior sheathing size and type
Floor
o Joist size and spacing
Foundation Wall
o Concrete or Masonry unit width
o Earth to wood separation distance
Footing
o Size
Radon
o Passive system with 6mil vapor barrier
Miscellaneous Construction Details
O Dmck:
o Floor plan/ side viewl dimensions
o Floor Joist/ decking direction, size and spacing
o Stairway tread rise & run and nosing
o Window and door Iocation and sizes
OWindow well locations ifapplicable
O Room usage labels
oSmoke detector locations
o Attic and crawl space access Iocations
o Fire Wall construction
o Ridgeeaveand valley lines
o Beam and girder size and Iocation
o Truss or raftesize, & connection
o Attic insulation/ air space baffle/ ventilation
o Size of ceiling gypsum wall board
o Sidingf exterior house wrap/ anchor bolts
• Insulation, vapor barrier, gypsum wall board
o Shor concrete floor size/ insulation
o Footing bottom to finished ground Ievel depth
o Horizontal @vertical reinforcement if any
o Reinforcement if any
0 Active system with 6 mil vapor barrier
o Footings/ postl and beam size and Iocations
O Handrail / Guard height & spacing
t1U3L
3775- trl
anL E C.nri 4'
e.
1
C.ove(eci
Ccor'' por
Project ';-`,g'
- 7::,.CEIVE D,
Q
ri-::::: 1 r3 2012
CSV PE_F1ri•CENT9
SUB # ' R E V. i4'• r---1
Existing
wall
Continuous 2x ledger
anchor by lag screws
Approved hanger
New rafter
Existing roof rafters or trusses
Galvanized metal joist or rafter hangers
Extend underlayment from
new roof a minimum of 18"
onto existing roof
Cont. 2x ledger
Secure ledger to wall with lag bolts @ 16° O.C.
Locate lag bolts to penetrate top plate or studs
Note: Remove brick veneer at top of wall
before installing continuous 2x ledger
' : Remove existing fascia
Existing wall
menzesslw
LopjM wnwiuiw „g 6
I_
n) o
= C
C)
(D
cf
� r
Lap underlayment a minimum of 18" under existing roofing felts
Solid 2x blocking on 2x12 or greater
Roof tie downs required
Existing Roof
Cont. 2x6 secured to existing roof with
fasteners at each rafter or truss
1
y)dep wnwiuiw „�r�
(II -0
-0
al
0
2.
CO N
iiCD
1;:
0).A.
X X
m 3
g
o -
3c
03
3
0..
m
0.
(D
0)
3
N
I --C"
153.
(D 3
X -0'731:1) gym
_o -v
n. FT; (0 —
0 3 s
Co (n
I N
(0 ! w o)
L
Bracing required
Approved metal
bracing
City of
SPOKANE VALLEY BUILDING DEPARTMENT
11707 E. Sprague Avenue #106, Spokane Valley, Washington 99206 - Tel 509-688-0036 - Fax 509-688-0037
Following is a typical cross-section for a residential garage. It may not represent the proposed project. If you are using this detail
as a portion of your plan submittal, please complete the requested information in the boxes provided on both sides of this sheet
This completed sheet, along with any additional information needs to be submitted with your apllication and be on site at the time
of inspection.
PROTECTION AND OPENINGS BETWEEN
DWELLINGS AND PRIVATE GARAGES SHALL HAVE:
1) MATERIALS APPROVED FOR ONE HOUR FIRE
RESISTIVE CONSTRUCTION ON THE GARAGE SIDE:
' 5/8" TYPE "X" GYP BOARD (HABITABLE SPACE ABOVE)
' 1/2" GYP BOARD (RESIDENCE/ATTIC, FLOOR/CEILING)
2) OPENINGS BETWEEN GARAGE AND RESIDENCE
SHALL BE EQUIPPED WITH SOLID WOOD DOOR, SOLID OR
HONEYCOMB CORE STEEL DOORS NOT LESS THAN 1 3/8",
OR 20 MINUTE FIRE RATED DOORS.
ALTERNATE FOUNDATION FOR
ACCESSORY BUILDINGS FROM
400 SQ. FT. TO 3000 SQ. FT.
SECTION A -A
•4 ••, •4 if. : t
•
0111=. d=•
• J
1E1 -11111i..4.4%..•.
111115_1k: •'•
•
1-211: •
.
NOTE:
Diagonal wall bracing required on
each comer and every 25 feet of wall.
Walls within 3 feet of a property line or
within 6 feet of a dwelling must be 1 hour
rated. (5/8" type "X" gypsum sheathing
on both sides of wall). Openings are not
permitted in these walls. Garages over
3,000 sq. ft. require protection when
closer than 20 feet to the property line.
Parapets may be required.
ENGINEERED TRUSS OR
RAFT
SIZW4D SPACING
tx O.C.
. Meta I ROOFING MATERIAL
ROOFING PAPER
Jt(
7// ROOF
SHEATHING
SOLID BLOCKING
BETWEEN.TRUSSES
t(
3, WALL SHEATHING
SIDING
DOUBLE TOP PLATE
WALL HEIGHT__
2x ( @ 2416.c.
PRESSURE TREATED
SOLE PLATE
6- MIN.
24" MIN.
11111=11111 � _
IIII1v
6" MIN
6"x12"
FOOTING
SLAB
I + 7
ANCHOR BOLTS
1/2"x9" MIN.
(7" INTO CONCRETE)
6' 0. C. OR APPROVED
ANCHOR INSTALLED
PER MANUFACTURER.
FOUNDATION PLAN
PLEASE COMPLETE THE FOLLOWING INFORMATION AND ADD ON THE DRAWING BELOW.
BUILDING DIMENSIONS:
GARAGE OPENING AND HEADER SIZE:
INDICATE THE LOCATION AND SIZE OF ALL WINDOWS AND DOORS ON THE PLAN.
WIDTH
R|0GE�1N�-- '~~
(
Please note that while every effort s made to assure the accuracy of the information contained in this brochure is
not warranted for accuracy. This document is not intended to address all aspects or regulatory requirements for a
project and should serve as a starting point for your investigation. For detailed nformation on a particular project,
permit, or code requirement refer directly to applicable file and/or code/regulatory documents or contact the
appropriate division.