2014, 10-20 Permit App: BLD-2014-2587 Remodel FireplaceCommunity Deve upment Department
Permit Center
*Wane11703 East Sprague Avenue, Suite B-3
Tel: (509) 688-0036
Spokane Valley, WA 99206
Fax: (509) 688-0037
410*Valley Permitcenter@spokanevallev.orq ! Project FlirilIMMIF ?.-
R _CEIVED
RESIDENTIAL CONSTRUCTION PERMIT APJL,If.i i ON In
Sr
El NEW CONSTRUCTION yj ADDITION/REMODEL d ACCESSORY BUILDING
Q DECK OTHER CSV PERMIT CENTER
(Staff Use Only)
PERMIT NUMBER:
PERMIT FEE:
7
SITE ADDRESS: ) 7jj 3 -E., n
ASSESSORS PARCEL NO.:
SUB
LEGAL DESCRIPTIO --.
RE\/.
BUILDING OWNER NAME:
NAME:
ADDRESS: ) / // j' ) ,.S s) () n /�/
CITY:< ikN VA // STATE: L�3 74 , ZIP: 6 ! O
)�j/��— /
C��— �� � � FAX: CELL: ,(11---C) `—
�' C r,91CS �
PHONE:
CONTACT NAME: b / C(--1'v`e
PHONE: �(S c b — @9s
CONTRACTOR NAME:
FAX: CELL:�J�%�f .)/ G 0
MAILING ADDRESS: Kq v 0 v _ f" � G R ✓�
CITY: S ( C3 STATE: LJ .s� , ZIP:
PHONE: `-�— c _ FAX: CELL:
CONTRACTOR LICENSE No.:
EXPIRES: CITY BUSINESS LICENSE NO.:
DESCRIBE THE SCOPE OF WORK IN DETAIL AND INDICATE USE & PROPOSED USE:
****YOU MUST COMPLETE THE FOLLOWING****
MARK N/A IF NOT APPLICABLE
Height to Peak:
Dimensions:
No. of Stories: /
Total Habitable
Space:
Main Floor SQ FT:
Upper Floor SQ FT:
Unfinished Basement SQ
FT: A)/A
Finished Basement SQ
FT:
Garage SQ FT:
/Ii/ A
Deck/Covered Patio SQ
FT: raj/
Impervious Surface
Area:
30% Slopes on
Property:
No. of Bedrooms:,,-) /A
Construction Type:
Heat Source:
Sewer or Septic: f t q
TOTAL COST OF PROJECT: $ s c,(1, ° c"
DISCLAIMER
The permitted verifies, acknowledges and agrees by their signature that: 1) if this permit is for construction or on a dwelling, the dwelling is/will
be served by potable water. 2) Ownership of this City of Spokane Valley permit Inure to the property owner. 3) The signatory is the property
owner or has permission to represent the property owner in this transaction. 4) All construction is to be done in full compliance with the City of
Spokane Valley Development code. Referenced codes are available for review at the City of Spokane Valley Permit Center. 5) The City of
Spokane Valley permit is not a permit or approval for any violation of federal, state or local laws, codes or ordinances. 6) Plans or additional
Information may be required to be submitted and subsequently approved before this application can be processed.
Signature
Date: /C9// j'7L
Updated 1-11-11 Page 1 of 1
http://www.spokanevalley.org/filestorage/124/938/210/948/1496/Building_Permit_-_Residential_11-11-11.doc
RESIDENTIAL CHECK LIST DIRECTIONS
Place a check mark in box next to each document required for complete submittal.
o SITE PLAN
o Property lines and dimensions
o Direction arrow pointing North and orientation to streets
o Proposed/existing buildings (footprint and dimensions)
o Utilities, septic tank/drain field locations and distances
o Setbacks to property lines
o Distance between buildings
o Right of way/easement location & sizes
o Driveway approach size and location
BUILDING PLANS (3 SETS) (minimum 1/8 inch scale or completely dimensioned)
❑ Elevations (Front/Rear/Sides) with roof peak and wall height including basement:
❑ Foundation Plan (crawlspace, basement or slab on grade):
o Footing sizes and locations
o Perimeter concrete foundation wall sizes
o Crawlspace ventilation
o Supporting wood cripple walls or beams
o Thickened concrete pads supporting
beams or girder trusses
O Floor Plan of each level (finished or unfinished) with dimensions:
o Floor Joist direction, size and spacing
o Header, beam or concrete lintel sizes
o Brace wall panel locations
o Water heater and furnace locations
o Exhaust fan locations
o Deck or concrete patio sizes and locations
❑ Roof Plan:
o Engineered truss direction and spacing
o Rafter and over frame direction, size and spacing
❑ Wall Section Detail including:
Roof
o Slope/ roofing material/ underlayment/ ice dam protection
o Sheathing size and type
Ceiling
o Joist size and spacing
Wall
o Height/ top plate/ stud size and spacing/ sole plate
o Exterior sheathing size and type
Floor
o Joist size and spacing
Foundation Wall
o Concrete or Masonry unit width
o Earth to wood separation distance
Footing
o Size
Radon
o Passive system with 6mil vapor barrier
Miscellaneous Construction Details
❑ Deck:
o Floor plan/ side view/ dimensions
o Floor Joist/ decking direction, size and spacing
❑ Stairway tread rise & run and nosing
o Window and door location and sizes
o Window well locations if applicable
o Room usage labels
o Smoke detector locations
o Attic and crawl space access locations
o Fire Wall construction
o Ridge, eave and valley lines
o Beam and girder size and location
o Truss or rafter size, spacing & connection
o Attic insulation/ air space baffle/ ventilation
o Size of ceiling gypsum wall board
o Siding/ exterior house wrap/ anchor bolts
o Insulation, vapor barrier, gypsum wall board
o Sheathing or concrete floor size/ insulation
o Footing bottom to finished ground level depth
o Horizontal & vertical reinforcement if any
o Reinforcement if any
o Active system with 6 mil vapor barrier
o Footings/ post/ and beam size and locations
o Handrail / Guard height & spacing
• It4151-611-)
els; Tts j,
e�ye s%Lre
vie ye e,Q. 54--
,/c/kr?)
4,na
8
16Y,f,,&//$'
•
,v';
Art&a)
; �J
6 ox
171.V) ( 2c.3c2,//7 J! 6 C..'2
• Oowze' wta-t- rit4s V2-" min -from firei
0 ,bnov& €r11n9 rock- iace, i rglac . q /wood
Project VGD-20(1-4'06.25
- RECEIVED
OCT 2 0-2014
CSV PERMIT CENTER
Valley
REVIEWED FOR CODE COMPLIANCE
BUILD, .
4111A�r:?•'''
FILE
SUB F
RE!- :
' CHIMNEYS AND FIREPLACES
R1001.9 Hearth and hearth extension. Masonry fireplace
hearths and hearth extensions shall be constructed of concrete
or masonry, supported by noncombustible materials, and
reinforced to carry their own weight and all imposed loads.
No combustible material shall remain against the underside
of hearths and hearth extensions after construction.
R1001.9.1 Hearth thickness. The minimum thickness of
fireplace hearths shall be 4 inches (102 mm).
R1001.9.2 Hearth extension thickness. The minimum
thickness of hearth extensions shall be 2 inches (51 mm).
Exception: When the bottom of the firebox opening is
raised at least 8 inches (203 mm) above the top of the
hearth extension, a hearth extension of not less than 3/8-
inch-thick
/8inch-thick (10 mm) brick, concrete, stone, tile or other
approved noncombustible material is permitted.
R1001.10 Hearth extension dimensions. Hearth extensions
shall extend at least 16 inches (406 mm) in front of and at
least 8 inches (203 mm) beyond each side of the fireplace
opening. Where the fireplace opening is 6 square feet (0.6 m2)
or larger, the hearth extension shall extend at least 20 inches
(508 mm) in front of and at least 12 inches (305 mm) beyond
each side of the fireplace opening.
R1001.11 Fireplace clearance. All wood beams, joists, studs
and other combustible material shall have a clearance of not
less than 2 inches (51 mm) from the front faces and sides of
masonry fireplaces and not less than 4 inches (102 mm) from
the back faces of masonry fireplaces. The air space shall not
be filled, except to provide fire blocking in accordance with
Section R1001.12.
Exceptions:
1. Masonry fireplaces listed and labeled for use in con-
tact with combustibles in accordance with UL 127
and installed in accordance with the manufacturer's
installation instructions are permitted to have com-
bustible material in contact with their exterior sur-
faces.
For SI: 1 inch = 25.4 mm.
MASONRY
2. When masonry fireplaces are part of masonry or
concrete walls, combustible materials shall not be in
contact with the masonry or concrete walls less than
12 inches (306 mm) from the inside surface of the
nearest firebox lining.
3. Exposed combustible trim and the edges of sheath-
ing materials such as wood siding, flooring and dry-
wall shall be permitted to abut the masonry fireplace
side walls and hearth extension in accordance with
Figure R1001.11, provided such combustible trim or
sheathing is a minimum of 12 inches (305 mm) from
the inside surface of the nearest firebox lining.
4. Exposed combustible mantels or trim may be placed
directly on the masonry fireplace front surrounding
the fireplace opening providing such combustible
materials are not placed within 6 inches (152 mm) of
a fireplace opening. Combustible material within 12
inches (306 mm) of the fireplace opening shall not
project more than `/8 inch (3 mm) for each 1 -inch
(25 mm) distance from such an opening.
R1001.12 Fireplace fireblocking. Fireplace fireblocking
shall comply with the provisions of Section R602.8.
SECTION R1002
MASONRY HEATERS
R1002.1 Definition. A masonry heater is a heating appliance
constructed of concrete or solid masonry, hereinafter referred
to as masonry, which is designed to absorb and store heat
from a solid -fuel fire built in the firebox by routing the
exhaust gases through internal heat exchange channels in
which the flow path downstream of the firebox may include
flow in a horizontal or downward direction before entering
the chimney and which delivers heat by radiation from the
masonry surface of the heater.
COMBUSTIBLE SHEATHING
EDGE ABUTTING MASONRY
12 IN. MIN. FROM FIREBOX
WOOD MANTEL
FRAME WALL
2 IN. CLEARANCE (AIR SPACE)
TO COMBUSTIBLE FRAMING
FIGURE R1001.11
CLEARANCE FROM COMBUSTIBLES
456 2012 INTERNATIONAL RESIDENTIAL CODE®