Loading...
2012, 05-23 Permit App: BLD-2012-0690 Remodelo ane VaIley% Community Development Department Permit Center 11703 East Sprague Avenue, Suite B-3 Spokane Valley, WA 99206 Tel: (509) 688-0036 Fax: (509) 688-0037 permitcenter@ spokanevalley.org RESIDENTIAL CONSTRUCTION PERMIT APPLICATION NEW CONSTRUCTION I ADDITION/REMODEL Q ACCESSORY BUILDING ED DECK L OTHER SITE ADDRESS: 4715 N. Progress, Spokane Valley, WA 99206 ASSESSORS PARCEL NO.: LEGAL DESCRIPTION: BUILDING OWNER NAME: Denise L. Darnell NAME: Denise L. Darnell ADDRESS: 2722 W Dean Ave cm: Spokane STATE: WA zip: 99206 PHONE: FAX: CELL: 509-280-5223 CONTACT NAME: Denise L. Darnell PHONE: FAX: CELL: 509-280-5223 CONTRACTOR NAME: Denise L. Darnell MAILING ADDRESS: 4715 N. Progress, Spokane Valley, WA 99206 Cm: Spokane STATE: WA ZIP: 99206 PHONE: FAX: CELL: 509-280-5223 CONTRACTOR LICENSE No.: EXPIRES: CITY BUSINESS LICENSE NO.: DESCRIBE THE SCOPE OF WORK IN DETAIL AND INDICATE USE & PROPOSED USE: dividing the laundry room in the finished basement in half & turning part of it into a 2nd bathroom dividing the laundry room in the finished basement in half & turning part of it into a 2nd bathroom ****YOU MUST COMPLETE THE FOLLOWING**** MARK N/A IF NOT APPLICABLE Height to Peak: n/a Dimensions: n/a No. of Stories: n/a 1 Total Habitable n/a Space: Main Floor SQ FT: 850 c� Upper Floor SQ FT: n/a Unfinished Basement SQ FT: n/a Finished Basement SQ FT: n/a Garage SQ FT:Deck/Covered n/a Patio SQ FT: n/a Impervious Surface Area: nla 30% Slopes on Property: n/a No. of Bedrooms: 4 Construction Type: Heat Source: electric Sewer or Septic: sewer TOTAL COST OF PROJECT: $ 500.00 DISCLAIMER The permitted verifies, acknowledges and agrees by their signature that: 1) if this permit is for construction or on a dwelling, the dwelling is/will be served by potable water. 2) Ownership of this City of Spokane Valley permit inure to the property owner. 3) The signatory is the property owner or has permission to represent the property owner in this transaction. 4) All construction is to be done in full compliance with the City of Spokane Valley Development code. Referenced codes are available for review at the City of Spokane Valley Permit Center. 5) The City of Spokane Valley permit is not a permit or approval for any violation of federal, state or local laws, codes or ordinances. 6) Plans or additional informatioy ay be required to be submittedpnd subsequently approved before this application can be processed. Effective October 28, 07 Page 1 of 2 P:\Community Development\02 Administration\03 Forms - Official Versions\Permit Center\Residential Construction Permit App 10.28.07.doc Spokane Yermrt Center 11703 E Sprague Ave, Suite B-3 Spokane Valley, WA 99206 (509)688-0036 FAX: (509)688-0037 Community Development permitcenter(a�spokanevalley.org Mechanical Permit Application Commercial 4. . erj- PERMIT NUMBER: PERMIT FEE: b' esidential SITE ADDRESS: L� 7 i.� i) S(JGY�1c�� v �i� < 1 111 aq 9o‘ - Building Owner Name: , c\.:n er ,J \ \\:7 •l�S \\ Phone. .age-.5�,3 Fax: Address: t) n r- c City_1_, State: Zip: `7`7 r Contractor ,� 1 - -5 c \ c Name: Phone: Fax: Address: City: State: Zip: License No: City Business Lic: Contact/Project Manager: \ Name: Phone: #UNITS FURNACES & SUSPENDED HEATERS -INSTALLATION OR RELOCATION Up to & including 100,000 BTU FURNACES & SUSPENDED HEATERS -INSTALLATION OR RELOCATION Over 100,000 BTU DUCT WORK SYSTEM HEAT PUMP/AIR CONDITIONER 0-3 TON AIR CONDITIONER Over 3-15 TON AIR CONDITIONER Over 15-30 TON AIR CONDITIONER Over 30-50 TON AIR CONDITIONER Over 50 TON GAS WATER HEATER GAS PIPING SYSTEM (each outlet) GAS LOG, FIREPLACE, & GAS INSERT APPLIANCE VENTS INSTALLATION, RELOCATION, REPLACEMENT REPAIRS OR ADDITIONS BOILER, COMPRESSORS, ABSORPTIONS SYSTEM 0 to 3 hp -100,000 BTU or Tess BOILER, COMPRESSORS, ABSORPTIONS SYSTEM BOILER, COMPRESSORS, ABSORPTIONS SYSTEM Over 3 -15 hp -100,001 to 500,000 BTU Over 15 - 30 hp - 500,001 to 1,000,000 BTU BOILER, COMPRESSORS, ABSORPTIONS SYSTEM Over 30 hp - 1,000,001 to 1,750,000 BTU BOILER, COMPRESSORS, ABSORPTIONS SYSTEM Over 50 hp - over 1,750,000 BTU AIR HANDLER (DOES NOT include ducting) AIR HANDLER (DOES NOT include ducting) Each unit up to 10,000 cfm, including ducts Each unit over 10,000 cfm EVAPORATIVE COOLERS(other than portables) VENTILATION AND EXHAUST Each fan connected to a singe duct VENTILATION AND EXHAUST VENTILATION AND EXHAUST Each ventilation system Each hood served by mechanical exhaust INCINERATORS Installation or relocation of residential INCINERATORS Installation or relocation of commercial APPLIANCES Range, Clothes Washer UNLISTED APPLIANCES Under 400,000 BTU UNLISTED APPLIANCES Over 400,000 BTU HOOD Type I HOOD Type II L P STORAGE TANK WOOD OR PELLET STOVE INSERT WOOD STOVE SYSTEM - FREE STANDING ❑CASH ❑ CHECK ❑ VISA ❑ MC CARD #: EXPIRES: VIN: SIGNATURE http://www.spokanevalley.org/uploads/Community Development/Documents/Forms/Building/MechanicalPermitApplication040309.doc R305.1.1 Basements. Portions of basements that do not contain habitable space, hallways, bathrooms, toilet rooms and laundry rooms shall have a ceiling height of not less than 6 feet 8 inches (2032 mm). Exception: Beams, girders, ducts or other obstructions may project to within 6 feet 4 inches (1931 mm) of the finished floor. SECTION R306 SANITATION R306.1 Toilet facilities. Every dwelling unit shall be provided with a water closet, lavatory, and a bathtub or shower. R306.2 Kitchen. Each dwelling unit shall be provided with a kitchen area and every kitchen area shall be provided with a sink. R306.3 Sewage disposal. All plumbing fixtures shall be con- nected to a sanitary sewer or to an approved private sewage dis- posal system. R306.4 Water supply to fixtures. All plumbing fixtures shall be connected to an approved water supply. Kitchen sinks, lava- tories, bathtubs, showers, bidets, laundry tubs and washing machine outlets shall be provided with hot and cold water. WALL 15" IN /WALL } 2? IN CLEARANCE 2? IN CLEARANCE For SI: 1 inch = 25.4 mm. 2009 INTERNATIONAL RESIDENTIAL CODE@ BUILDING PLANNING SECTION R307 TOILET, BATH AND SHOWER SPACES R307.1 Space required. Fixtures shall be spaced in accor- dance with Figure R307.1, and in accordance with the require- ments of Section P2705.1. R307.2 Bathtub and shower spaces. Bathtub and shower floors and walls above bathtubs with installed shower heads and in shower compartments shall be finished with a nonabsorbent surface. Such wall surfaces shall extend to a height of not less than 6 feet (1829 mm) above the floor. SECTION R308 GLAZING R308.1 Identification. Except as indicated in Section R308.1.1 each pane of glazing installed in hazardous locations as defined in Section R308.4 shall be provided with a manufacturer's desig- nation specifying who applied the designation, designating the type of glass and the safety glazing standard with which it com- plies, which is visible in the final installation. The designation shall be acid etched, sandblasted, ceramic -fired, laser etched, embossed, or be of a type which once applied cannot be removed without being destroyed. A label shall be permitted in lieu of the manufacturer's designation. Exceptions: 1. For other than tempered glass, manufacturer's desig- nations are not required provided the building official 24 IN. CLEARANCE IN FRONT OF OPENING SHOWER WALL WATER CLOSET OR BIDET 15IN. pa I 21 IN.� CLEARANCE WATER CLOSETS WALL FIGURE R307.1 MINIMUM FIXTURE CLEARANCES WALL 55 SliokaneValley® 11703 E Sprague Ave Suite B-3♦ Spokane Valley WA 99206 ♦509.720.5240 ♦ Fax: 509.688.0037 • Twelve Things You Must Know!! 1. WAC Amendment Table R302.1 Fire Resistant Construction for Exterior Walls — Eave or other projections for walls Tess than 5 feet from property lines require one hour fire protection on the underside unless fire blocking is provided at the wall or no gable end vent is installed. This effectively eliminates any venting at the exterior wall if within 5 feet of the property line without fire protection. 2. R319.1 Address Numbers — Buildings shall have approved address numbers consisting of a minimum 4 inches high and a minimum stroke width of % inch plainly legible and visible from the street. 3. WAC Amendment R327.1 Protection Against Radon —State adoption of IRC Appendix F for mitigation measures applicable for buildings constructed in "High Radon Potential Counties" (Spokane County). Appendix F Section AF101.1 (WAC Amendment) no longer permits un -vented (conditioned) crawl spaces. Appendix F further requires passive radon vents to be installed in vented crawl spaces. WAC Amendment to R408.2 permits 1:300 sq/ft ratios for ventilating crawl spaces. 4. Table R404.1.2(1) Minimum Horizontal Reinforcement for Concrete Basement Walls - Horizontal reinforcement in all below ground stem walls is required with a minimum of (1) #4 rebar within 12 inches of the top of the wall and (1) #4 rebar near mid height if less than 8 feet, and (1) #4 rebar within 12 inches of the top of the wall and (1) #4 rebar at 1/3 points if more than 8 feet. Minimum vertical reinforcement is listed in Table R404.1.2(8). 5. R502.2.2.3 Deck Lateral Load Connection — Hold-down tension devices shall be installed in not less than two locations per deck, and each device shall have and allowable stress design capacity of not less than 1500 pounds. 6. R506.2.3 Vapor Retarder —A 6 mil polyethylene or approved vapor retarder with joints lapped not less than 6 inches shall be placed between the concrete floor slab and the base course or the prepared subgrade where no base course exists. Exception is detached garages and other unheated accessory structures. 7. R602.10.8 Braced Wall Panel Joints—All vertical joints shall occur over and be fastened to common studs. Horizontal joints shall occur over and be fastened to common blocking of a minimum 1 Y2 inch thickness. Exception omits blocking if twice the required minimum length of braced wall panels are provided. 8. 8602.10.9 Cripple Wall Bracing— Cripple walls shall be braced with a type and length of bracing as required for the wall above multiplied by a factor of 1.15 and decreasing the distance between brace wall panels to 18 feet instead of 25 ft. 9. R612.2 Window Sills — Window fall prevention protection similar to guardrails (4 inch diameter sphere) is required for operable portions of windows Tess than 24 inches above the finished floor, and greater than 72 inches above the adjacent exterior grade or surface below. 10. R702.4.2 Tile Backer Board — Section requires cement, fiber -cement, or glass mat gypsum backers for tile installation in tub and shower areas and wall panels in shower areas. 11. R703.2 and Table R703.4 — Water Resistive Barrier Felt, or other approved barrier (house wrap) is required over all exterior wall studs or sheathing, and there is no longer an exception for not requiring such felt/barrier under panel sidings with shiplap joints. 12. Washington State Energy Code Section 505.2 Exterior Lighting- Luminaires providing outdoor lighting and permanently mounted to a residential building or to other buildings on the same lot shall be high efficacy (compact florescent with pin style base or similar efficient light source) lamps. Exception allows incandescent fixtures controlled by motion sensors with integral photo sensors. ■ ■ 11,TO FIELD INSPECTI ON CORRECTIO Cv S L44,s THIS BUILDING SUBJECT c h v+4 6® L s ..,il9y rvG4 1 toirlrd 5/44/7 �-,+5* 3,20 4 h TO 1(1!1.7 a iroel 971 u' L& T r t 3L8UR 03 iG ViOtT .131L9824:1- 1 meow Foot com cativutsOixii SI"'bMive YAup( outcome OMISION CITY COPY