2014, 06-18 Permit: BLD-2013-1760 Res. Energy Compliance Cert. Property Address: "ZC S 5 (C i' k Spc iean t �C4� p`/
Conditioned Floor Arca: i 3E� Date: I j 14
Builder or registered design professional:
140 Si„►�,ticoin Sam i-z) (2��) 9o- -5°�5
Signature: ji;; R-Vaiues
Ceiling: Vaulted R-Jf Floors: Over unconditioned space R-
Attic R- c{ Slab on grade floor R. ��
N.-J.
Walls: Above grade R-2-/ Doors: Gi%ZQ R-
V
ti
Below,int. R-,0 5/2 R-
Below,ext. R-
::./.!
- R-
A
\.i U-Factors and SHGC
r NERC.rating(or) Windows 1'(2�3Z SHCiC- NIA
r Default rating{Appcndn.4 WS11 241121Skylights 1:-
"It
- SHtiC' NIA
:» Table 406.2 Opium's) Total 406.2 Credits
itv
Heating,Coate& Ue astfd Hot Water
System Type Efficiency
'74 Heating; S �
i
Cooling
;r
Duct&Building Air Leakage
.74
hj
All ducts HVAC in conditioned space ( yes no Insulation R- /0
Air handler present ( yes no i
Test"target C'FM;a;25Pa fest Result CFM(a`25Pa
Building air leakage target:AC H�<5.0-Tested leakage:ACH.,o- 4,6
System type. Rated annual generation Kwh
.x :';trq 41 7 131V WASHINGTON STATE UNIVERSITY
1" EX`ERISION ENERGY PROGRAM
Duct Leakage Affidavit (New Construction)
Permit#:
House address or lot number: (4'n 5elk‘fk
City: \lc./ Zip:
Cond. Floor Area (ft2): XI Source (circle one): Plan Estimated Measured
❑ Duct tightness testing is not required. The total leakage test is not required for ducts and air handlers located
entirely within the building thermal envelope. Ducts located in crawl spaces do not qualify for this exception.
Air Handler in conditioned space? yes ❑ no Air Handler present during test?,pi yes ❑ no
Circle Test Method: Leakage to Outside otal Leakage J
Maximum duct leakage:
Post Construction,total duct leakage: (floor area x .04) = CFM@25 Pa
Post Construction, leakage to outdoors: (floor area x .04) = CFM@25 Pa
Rough-In,total duct leakage with air handler installed: (floor area x .04) = S S CFM@25 Pa
Rough-In,total duct leakage with air handler not installed: (floor area x .03) = CFM@25 Pa
Test Result: Lit,„ CFM@25Pa
Ring (circle one if applicable): Open 1 3
Duct Tester Location: r oS' Pressure Tap Location: -zx-.�++�
I certify that these duct leakage rates are accurate and determined using standard duct testing protocol.
Company Name: Technician: a X
Technician Signature:
Date: /21 / f £�
Phone Number: (ZC�) (�(„ q• &70c/